HT TX/RX MCS rate indexes supported: 0-15 Minimum RX AMPDU time spacing: 16 usec (0x07) Maximum RX AMPDU length 65535 bytes (exponent: 0x003)
Unknown printer 8812 driver free#
Hostapd_cleanup_iface: free iface=0x931860 Hostapd_interface_free: free hapd 0x933b40 Nl80211: Teardown AP(wlp7s0u1) - device_ap_sme=1 use_monitor=1 Nl80211: Set mode ifindex 5 iftype 2 (STATION) Netlink: Operstate: ifindex=5 linkmode=0 (kernel-control), operstate=6 (IF_OPER_UP) Nl80211: Remove monitor interface: refcount=0 Nl80211: Skip disabling of Probe Request reporting nl_preq=0x88888888881ba959 while in AP mode Hostapd_interface_deinit_free: driver=0x4a3740 drv_priv=0x9348e0 -> hapd_deinit Hostapd_free_hapd_data: Interface wlp7s0u1 wasn't started Nl80211: sta_remove -> DEL_STATION wlp7s0u1 ff:ff:ff:ff:ff:ff -> -22 (Invalid argument) Hostapd_interface_deinit_free: num_bss=1 conf->num_bss=1 Wlp7s0u1: interface state HT_SCAN->DISABLED Nl80211: Failed to set channel (freq=5180): -22 (Invalid argument) Mode: IEEE 802.11a Channel: 36 Frequency: 5180 MHz HT40: control channel: 36 secondary channel: 40 Wlp7s0u1: Event SCAN_RESULTS (3) received Wlp7s0u1: nl80211: New scan results available Nl80211: Drv Event 34 (NL80211_CMD_NEW_SCAN_RESULTS) received for wlp7s0u1 RTM_NEWLINK: ifi_index=5 ifname=wlp7s0u1 wext ifi_flags=0x1003 () I don't know if I need to do change/add anything else in my nf to get it ac mode to work. It works with 80211n in 5Ghz but not 80211ac, it could be my fault though, I'm merely uncommenting the line ieee80211ac=1. Instead I'm using rtl8812AU_8821AU_linux from abperiasamy here on github. I can get it to run with those patches and the previous version of hostapd (2.2).
0 kommentar(er)
